What are the operating steps of hardware processing?
Home  > NEWS  > 

What are the operating steps of hardware processing?

What are the operating steps of hardware processing?

2018-12-19

   First, all employees are checking whether their clothing meets the requirements before doing anything. Slippers, high heels and clothing that affect safety are prohibited, and hard hats are required for long hair. If you find that you are unwell at work, you should leave your job immediately and report to the leader. Operation should be serious, prohibiting sputum, mutual cooperation, operators should not operate in an irritated, tired state, to avoid attacks and ensure safe operation.

  Second, before the mechanical work, check whether the machine is filled with lubricating oil, then start and check whether the clutch and brake are normal, and operate the machine for 1-3 minutes. If the machine is faulty, it is forbidden to operate.

  Third, when the mold is replaced, the power supply is first closed, and the punching machine can stop the operation before the device can be turned on and the mold can be debugged. After the adjustment of the device is finished, manually move the flywheel to test twice, to see if the upper and lower molds are symmetrical and reasonable, and whether the screws are consolidated or not, and whether the pressure ring is in a reasonable orientation.

  Fourth It is necessary to wait for other personnel to leave the mechanical operation area and take away the debris on the workbench before starting the power to start the machine.

  Fifth After the machine is started, it shall be transported by one person and mechanically. Others shall not press the electric button or the foot pedal switch board, and may not put the hand into the mechanical operation area or move the movement of the machine by hand. When working in machinery, it is forbidden to put your hand into the operation area of the slider. It is forbidden to take and put the workpiece by hand. It is necessary to use the conforming norms when taking and placing the work piece in the die. If the machine is found to have an abnormal sound or the machine fails, the power switch should be closed to view.

  Sixth When leaving work, the power should be turned off, and the products, trims and sundries on the post should be arranged to ensure the working environment is clean and safe.

  The above operating procedures are necessary to consciously abide by, do not operate in violation of the rules, failures, should be repaired by the repairing personnel, the power should be immediately removed from the power supply, and other relevant departments to post-processing, all consequences of violation of the operating procedures, the parties themselves.


Chat Online 编辑模式下无法使用
Chat Online inputting...